Project

General

Profile

error after new install: diseqc: failed to set voltage (e=No such file or directory)

Added by bob 808 almost 9 years ago

I have setup a new ubuntu server and installed the latest master branch tvheadend. My card is seen ok, but when I try to configure the setup my channel scan doesnt do anything. Looking in the log this is the error I am seeing:

diseqc: failed to set voltage (e=No such file or directory)

I have a single source into each tuner and this is setup to the sat network with the full disecq box unchecked. The sat card is a TBS dual tuner s2 card. Any ideas how I can work out the issue here?

Thanks


Replies (3)

RE: error after new install: diseqc: failed to set voltage (e=No such file or directory) - Added by bob 808 almost 9 years ago

If it helps, I am using a TBS 6981 card - I didnt install any new drivers, just a clean 15.10 install and tvheadend and tvh saw the card - it just wont work with the error above when scanning.

I just tried to install the linux drivers from tbs and now the card wont even load!

RE: error after new install: diseqc: failed to set voltage (e=No such file or directory) - Added by jamp man almost 9 years ago

funny, got the same error message with the same card. I am using a 2-port switch and pre-defined mux list 19.2E:Astra

edited:
solved it by installing correct firmware. saw it in dmesg output
see [[https://github.com/ljalves/linux_media/wiki/CX24117-firmware]]

    (1-3/3)