Project

General

Profile

Harware CI

Added by Ivar Lumi about 8 years ago

Hi,

I have HTS Tvheadend 4.1-360, i can't get encrypted channels to work.
Tv adapter is TBS 6290SE DVB-T.
System is TBS MOI+.

I don't see how to enable CI CAM ? (I have seen images for DVB-S tuner settingfs there is CI checkbox, but that doesn't exist in my settings ..)
(If understand right, since 4.x hardware CI CAM are supported and no oscam needed)


Replies (5)

RE: Harware CI - Added by Mike Ebner about 8 years ago

Hi,
do you have a tvheadend version with dvben50221 enabled. I've had the same issue looking for hours before I finally figured that I need to build my own tvheadend version with --enable-liben50221. Now the CA show up on the adapters tap.
Regards,
Michael

RE: Harware CI - Added by Ivar Lumi about 8 years ago

Hi,

I'm not good at linux, so compiling it on linux a bit hard.

Currently running OSCAM and all works ok.

RE: Harware CI - Added by Manuel Menz about 8 years ago

Hi,

i also did not see the CA Interfaces in my TV Adapters tab. I've compiled TvHeadend with the option --enable-liben50211 but the CAs did not appear.
AUTOBUILD_CONFIGURE_EXTRA=--enable-libffmpeg_static\ --enable-trace\ --enable-debug\ --enable-liben50221 ./Autobuild.sh

My DVB Hardware is a TBS5990 with two CA Interfaces.
I've tested the DVB-Hardware before i bought me my Hardware TvHeadend in VMware and as i remember there was the CAs in the TV-Adapters.

Regards
Manuel

RE: Harware CI - Added by Mike Ebner about 8 years ago

Hi,
I have a similar setup and the CA modules are shown under adaptors as in the screenshot. Did it say liben50221 = yes when you ran ./configure?
Regards,
Michael

ca.JPG (44.7 KB) ca.JPG

RE: Harware CI - Added by Manuel Menz about 8 years ago

Hi,

no, when i run ./configure the liben50221 did not appear in the output?

checking for cc libdvben50221 ... fail
Wich lib have i to install?

Look on my screenshot no CA's there

Regards
Manuel

EDIT:

Got it. You have to install sudo apt-get install dvb-apps. After installing that in ./configure the liben50221 is there. After rebuild and reinstall tvheadend the CAs are there :-).

Thanks a lot

Regards
Manuel

    (1-5/5)