Tvheadend

Hi,
do you have a tvheadend version with dvben50221 enabled. I've had the same issue looking for hours before I finally figured that I need to build my own tvheadend version with --enable-liben50221. Now the CA show up on the adapters tap.
Regards,
Michael

Hi,

I'm not good at linux, so compiling it on linux a bit hard.

Currently running OSCAM and all works ok.

Hi,

i also did not see the CA Interfaces in my TV Adapters tab. I've compiled TvHeadend with the option --enable-liben50211 but the CAs did not appear.
AUTOBUILD_CONFIGURE_EXTRA=--enable-libffmpeg_static\ --enable-trace\ --enable-debug\ --enable-liben50221 ./Autobuild.sh

My DVB Hardware is a TBS5990 with two CA Interfaces.
I've tested the DVB-Hardware before i bought me my Hardware TvHeadend in VMware and as i remember there was the CAs in the TV-Adapters.

Regards
Manuel

Hi,
I have a similar setup and the CA modules are shown under adaptors as in the screenshot. Did it say liben50221 = yes when you ran ./configure?
Regards,
Michael

Hi,

no, when i run ./configure the liben50221 did not appear in the output?

checking for cc libdvben50221 ... fail
Wich lib have i to install?

Look on my screenshot no CA's there

Regards
Manuel

EDIT:

Got it. You have to install sudo apt-get install dvb-apps. After installing that in ./configure the liben50221 is there. After rebuild and reinstall tvheadend the CAs are there :-).

Thanks a lot

Regards
Manuel