Tvheadend

2014-09-26

14:56 Tvheadend General: RE: Rotor(Motor) Support Latest Information.

Hi Jaroslav,
The fix works!
I have tested to switch from 0.8W to 13E back and forth many times in a row. No issue... o o

2014-09-25

20:59 Tvheadend General: RE: Rotor(Motor) Support Latest Information.

Hi Philip,
The latest build works perfectly for me too.
I hope that Jarsolav can have a quick look at the rate is... o o

2014-09-23

19:26 Tvheadend General: RE: Rotor(Motor) Support Latest Information.

Philip Reynolds wrote:
> Hi o o,
> did you have any luck? I'm now using build 1560, and couldn't get the it switchi... o o

2014-09-21

17:00 Tvheadend General: RE: Rotor(Motor) Support Latest Information.

Jaroslav Kysela wrote:
> o o wrote:
> > The rotor does not move from 0.8W to 4.8E.
> > Here is the log:
> >
> >... o o

15:18 Tvheadend General: RE: Rotor(Motor) Support Latest Information.

The rotor does not move from 0.8W to 4.8E.
Here is the log:... o o

11:37 Tvheadend General: RE: Rotor(Motor) Support Latest Information.

Jaroslav Kysela wrote:
> Some new commits in the tvh master source tree:
>
> USALS grace time calculation fix (so... o o

10:05 Tvheadend General: RE: Rotor(Motor) Support Latest Information.

Thanks for your effort Jaroslav!
Unfortunately it is not possible to read out the current position from the rotor ... o o

2014-09-20

17:38 Tvheadend General: RE: Rotor(Motor) Support Latest Information.

Hi Philip,
I have made a horrible patch that you can try if you dare :-)
Replace the attached file with /tvheaden... o o

09:38 Tvheadend General: RE: Rotor(Motor) Support Latest Information.

The rotor moves the dish to the correct position, but then tvheadend is stuck in an infimite loop. Here is an example... o o

2014-09-19

17:53 Tvheadend General: RE: Rotor(Motor) Support Latest Information.

Jaroslav Kysela wrote:
> o o wrote:
> > I did a very quick test (tvheadend 3.9.1526~g4bce3dc) but the stream status... o o