Project

General

Profile

Bug #1925

Bug #1929: TVadapters network error when implementing unicable switch

scanning chanels for Eutelsat 36.0E

Added by Sergey Borsukov almost 11 years ago. Updated almost 11 years ago.

Status:
Invalid
Priority:
Normal
Assignee:
-
Category:
DVB
Target version:
-
Start date:
2014-01-12
Due date:
% Done:

0%

Estimated time:
Found in version:
3.9.355
Affected Versions:

Description

How do I configure the satellite Eutelsat 36.0 E? After the changes associated with en50494 impossible to scan for channels, tvheadend does not automatically determine the channels and ID muxes. Unfortunately I don't know what should be the values ​​of ID, frequency, pin, etc.

History

#1

Updated by Raymond Paulsen almost 11 years ago

i have similar issues:

in a network setup with 1 card and advanced network configuration its impossible to select the generic switch for port selection, the only valid valid is unicable (en50494) seems its not possible to select a different switch type then unicable, generic is disabled

#2

Updated by Adam Sutton almost 11 years ago

  • Category changed from Service Mapping to DVB
  • Status changed from New to Need feedback

Can you please confirm whether this is the same issue reported in #1929. I.e. you're not trying to use Unicable, its just the config is getting in the way?

Adam

#3

Updated by Sergey Borsukov almost 11 years ago

Exactly, en50494 prevents to configure, when I choose "none" -- there is still 50494 and it doesn't scan services. I'm not trying to use Unicable, only "advanced" --> "circular 10750". Now going to check fresh git. Thank you!

#4

Updated by Sergey Borsukov almost 11 years ago

Now scanning is correct. Thanks again :)

#5

Updated by Adam Sutton almost 11 years ago

  • Status changed from Need feedback to Invalid
  • Parent task set to #1929

Duplicate of #1929.

Also available in: Atom PDF