Project

General

Profile

Forums » General »

Add DVB Network by Location showing an empty window

Added by bernie carter over 11 years ago

I had tvheadend working, then i selected and deleted all the multiplexes that were found. After i restarted and went to scan for channels, i clicked on "Add DVB Network by Location", and all that appears is a window with the "By Location" Tab. There are no folders displayed, like there should be.

Anyone have any idea to reset this?

Thanks

tv.jpg (33 KB) tv.jpg screenshot

Replies (4)

RE: Add DVB Network by Location showing an empty window - Added by Mark Mennens over 11 years ago

I have the same issue,

if i try to do the w_scan in the console i do get someting... but then nothing..

562000: (time: 02:00) (time: 02:01) signal ok:
        QAM_AUTO f = 562000 kHz I999B8C999D999T999G999Y999
Info: no data from NIT(actual)

tune to: QAM_AUTO f = 562000 kHz I999B8C999D999T999G999Y999
(time: 07:05) Info: no data from PAT
Info: no data from SDT(actual)
Info: no data from NIT(actual)
dumping lists (0 services)
Done.

how to fix this?

RE: Add DVB Network by Location showing an empty window - Added by bernie carter over 11 years ago

Did you perform a scan then select and delete all multiplexes found before the location list disappeared?

RE: Add DVB Network by Location showing an empty window - Added by Mark Mennens over 11 years ago

nope,

the list was empty on the first try..

i know added a manual Mux with exactely the same info as w-scan used..
and i got my channels now :)

But i still don't get why it shows an empty window..

(i'm running it on my raspberry pi with raspbmc on it..)

RE: Add DVB Network by Location showing an empty window - Added by Mike Holmes over 11 years ago

I have the same issue on raspbmc. Looked high and low for a way to get the lists back, I did see them the first couple of times, would settle for a way to type them by hand.

    (1-4/4)