Project

General

Profile

Nimiq 1 & 4 w/ Headend

Added by Ron Rankor about 12 years ago

Hello,

New to Headend and trying to figure out how to configure Nimiq 1 & Nimiq 4. I'm using a 22khz switch with N1 set to on and N4 set to off. I've setup up DVBLogic, DVB Dream and MyTheatre, but I'm a little stumped with this software....want to make the move to linux from Win. If it has to do with the mux tab, what would I input in there? On a side note, my Genpix is recognized fine.

Thanks.


Replies (1)

RE: Nimiq 1 & 4 w/ Headend - Added by Adam Sutton about 12 years ago

Someone more knowledgeable than me will probably give you a better answer. But I think if you create 2 sat conf entries:

Configuration->Adapters->Satconf

one on port 0 and one on port 1 (name them accordingly so you know which is which). And then I think you need to add the network locations one for each config and let it scan.

But I'm not that familiar with this bit of the code as I don't use switching myself.

Adam

    (1-1/1)