Softcam problems
Added by Stefan . over 7 years ago
I have been using ffdecsawrapper successfully with MythTV. But due to some problems with MythTV/Kodi i decided to try TVH. I'm building from source and downloaded the latest and have enabled both dvbcsa and tvhcsa.
Both gets enabled:
tvhcsa yes
bundle no
pngquant no
dvbcsa yes
My two problems is first that even though it is enabled, I don't get a CSA tab to do the configuration.
The other problem is that if I try to use ffdecsawrapper with TVH, a few seconds after starting TVH my whole computer locks up and I need to do a hard reset. But if I can somehow enable CSA in TVH the second problem can be ignored. Even though it is strange that it works with MythTV.
Any suggestions to what I could try? Anything else that needs to be enabled during ./configuration?
Replies (3)
RE: Softcam problems - Added by saen acro over 7 years ago
In general there is a check for CA
and also Expert mode
RE: Softcam problems - Added by Stefan . over 7 years ago
Thank you. Had to enable Expert mode in Base settings. Not that obvious. If you enable it in configuration it should at least show the config tab.
RE: Softcam problems - Added by saen acro over 7 years ago
https://tvheadend.org/boards/4/topics/24116
and no problems