Project

General

Profile

Forums » General »

Does Tvheadend 4.x work with Hauppauge Nova-T 500 hardware and DVB-T muxes?

Added by Paul Ryan about 9 years ago

Hi,

I have tvheadend 3.6 running on the above hardware but if I try to upgrade to any of the 4.x releases or the git head, it cannot tune into any of the muxes.

Before I go down the route of debugging card drivers, linuxdvb and tvheadend integration, does anyone else have this setup? Can they get it to work with tvheadend 4.x? Is it just my setup?

Thanks,

Paul


Replies (2)

RE: Does Tvheadend 4.x work with Hauppauge Nova-T 500 hardware and DVB-T muxes? - Added by Mark Clarkstone about 9 years ago

Paul Ryan wrote:

Hi,

I have tvheadend 3.6 running on the above hardware but if I try to upgrade to any of the 4.x releases or the git head, it cannot tune into any of the muxes.

Before I go down the route of debugging card drivers, linuxdvb and tvheadend integration, does anyone else have this setup? Can they get it to work with tvheadend 4.x? Is it just my setup?

Thanks,

Paul

I have three dibcom USB tuners (The NOVA-T 500 is essentially two dibcom usb tuners stuck on a board) & they all work fine with 4.x (4.1.389 in my case) so I don't see why yours aren't working correctly, make sure to check the frequencies, 3.x used 000000 and added extra zeros whereas 4.x+ uses 000000000 for DVB-T/T2.

RE: Does Tvheadend 4.x work with Hauppauge Nova-T 500 hardware and DVB-T muxes? - Added by Paul Ryan about 9 years ago

Hi,

Thank you for your help Mark!

I have this working with the master branch now; I just rebuilt it and ran it. I must have not been inputting the frequency correctly.

Paul

    (1-2/2)