Forums » Tutorial and setups »
Unicable LNB - SCR
Added by fatez fatez over 9 years ago
Hi,
i have a problem with the configuration on my setup : Sky IT with unicable SCR (the lnb is : SCR LNB with Legacy Model : FR8-Q2S)
Here is the config of my Dreambox settings :
With this config i can't have any problem.
So, how can i configure tvheadend with lnb unicable in SCR mode?
thanks
Replies (5)
RE: Unicable LNB - SCR - Added by Stephan Winter over 9 years ago
I have a DD Cine S2 v.6.5 running with Unicable connected to a Kathrein switch and it works flawlessly !?
Can you post a screen shot of TVH setup?
RE: Unicable LNB - SCR - Added by Sascha Kuehndel over 9 years ago
Have you tried to disable "tune before diseqc" and "full diseqc"?
One have reported, that this works, for him.
Sascha
RE: Unicable LNB - SCR - Added by Stephan Winter over 9 years ago
This is how it looks in my setup:
RE: Unicable LNB - SCR - Added by Boba Fett almost 9 years ago
hi there,
i have the same problem like fatez fatez. i'm using tvheadend on debian jessie (4.0.8 stable) with a dd cine2 6.5
on legacy ports with universal lnb settings i don't have any trouble to get it working.
on an unicable lnb (http://www.amazon.de/Markenprodukt-24448-Uni-Ein-Kabel-LNB-UK102/dp/B008509W8S) my dreambox works
fine. but tvheadend always brings on "data failed" on scanning the satellite.
i tried the unstable and even building from git, too - but without success. i also tried the tip from sascha to disable "tune before diseqc" an "full diseqc"
none of the frequency - scr-id combo will work.
can anyone help me to get it running ??? show up his settings or a howto would be great. thank you in advance
sLOID.