Project

General

Profile

setting Multiswitch 17/8 with TVHeadend

Added by Mounir Khiali about 10 years ago

Hello
does tvheadend support a Multiswitch 17/8? I have went trough the setting and tried different variations but could not find a good setup any one with any information will be helpful
I did try the following setup but with no results
https://tvheadend.org/boards/4/topics/12335


Replies (2)

RE: setting Multiswitch 17/8 with TVHeadend - Added by Rob vh about 10 years ago

This is for tvheadend 3.9:
I have a 17/8 in use, except I do not use the terrestrial port.
First you go to Networks and you define the orbital positions that your LNBs are looking at. 4 LNBs means 4 networks. You should use a pre-defined mux for your first attempts.
For each of the adapters that tvheadend automatically finds, you specify a satconfig "4-port switch." in the TV adapters tab.
Then go into "4-port switch" entries (for each adapter) and select the network name for each diseqc code: AA=LNB1, AB=LNB2, etc.
In older versions you would now have to restart tvheadend for the initial mux scan to start. Last time I did a manual scan was in June.
I do not know/care how to add the terrestrial port.

RE: setting Multiswitch 17/8 with TVHeadend - Added by Mounir Khiali about 10 years ago

that worked thank you so much for the clarification

    (1-2/2)