Project

General

Profile

Feature #6022

Update EPG in batches of streams

Added by Tomas Ulicky over 3 years ago. Updated over 3 years ago.

Status:
Rejected
Priority:
Normal
Assignee:
-
Category:
EPG
Target version:
-
Start date:
2021-03-15
Due date:
% Done:

0%

Estimated time:

Description

Hi,

I have in muxes 1000 IP TV IP addresses, that links to 100 channels.
When EPG grabber cron starts OTA job, whole gigabit connection is utilized to point where it cant even respond to pings.
After 5-10minutes network stabilize and all is fine again.
EPG grabber start scanning all addresses at once and each stream is around 3-5 Mbps (some of them are dead).

Is there a feature, or how to instruct EPG grabber to run in batches of 10 streams, than another 10 etc.
These 10 can be input variable.

Thanks

History

#1

Updated by Tomas Ulicky over 3 years ago

Or maybe better than batch of 10 it this setting could be "No more than x EPG streams" so when one stream finish another is processed from queue.
Of course each stream will have timeout which already exists in settings as "EPG scan time-out in seconds (30-7200)", because bad streams fill queue.

#2

Updated by Flole Systems over 3 years ago

  • Status changed from New to Rejected

Questions like this should be asked in the forum. You can limit the amount of concurrent streams already in the network settings.

Also available in: Atom PDF