Project

General

Profile

Bug #3634

Can't map channels after initial setup

Added by John Doe over 8 years ago. Updated over 8 years ago.

Status:
New
Priority:
Normal
Assignee:
-
Category:
Configuration
Target version:
-
Start date:
2016-03-15
Due date:
% Done:

0%

Estimated time:
Found in version:
4.0.8-3~gc870eb9~wheezy
Affected Versions:

Description

A few weeks ago I installed the latest stable tvheadend and it works well so far. When I set it up again I mapped all channels, but later on I found some more channels on frequencies which don't normally work during the day (which interfere with DVB-C), when I tried to map those to channels, nothing happens. I see 0/0 for a moment, then just an empty bar, and sometimes the window doesn't even show up and it just reports 'comet failure [e=Cannot set property 'innerHTML' of undefined]'.

The channels are enabled when using map selected. Map all doesn't work either.

History

#1

Updated by Jaroslav Kysela over 8 years ago

The channels must be scanned properly. If they don't run, TVH might not know if it's TV or RADIO (depends on the method which broadcaster uses to hide them).

What's in the service info dialog for these channels?

Also available in: Atom PDF