Bug #2561
closed
Wrong LNB initialization (linuxdvb)
0%
Description
After last update from b0e030b326c04c5c16e7a1bac59e0540fb8bb2d5, descrambling stopped to work for me.
I suspect some changes in linuxdvb.
Oscam only gets information about channel, but does not send ECM to tvheadend.
After downgrading to b0e030b326c04c5c16e7a1bac59e0540fb8bb2d5 everything works well again.
Updated by Jaroslav Kysela over 10 years ago
Could you retest with "Full DiseqC" switch enabled ?
Updated by Rafal Kupiec over 10 years ago
Yes I can, however I dont have multiswitch connected, so i think this should make no difference.
I have LNB connected directly to Cine S2.
Updated by Jaroslav Kysela over 10 years ago
It affects also polarization (H/V) and band (Lo/Hi) settings.
You may also try to set "Tune Repeats" to 1. Previously, two tune requests were sent to kernel...
Updated by Rafal Kupiec over 10 years ago
I will check it later and post an update.
Updated by Rafal Kupiec over 10 years ago
Upgraded to 3.9.2581 - same issue.
Enabling "Full DiseqC" as suggested seems to fix this issue.
Updated by Jaroslav Kysela over 10 years ago
Provide "--trace diseqc" to check..
Updated by Jaroslav Kysela over 10 years ago
- Subject changed from Descrambling with capmt does not work to Wrong LNB initialization (linuxdvb)
I believe this issue should be resolved in v3.9-2284-g3c5d409 .
Updated by Jaroslav Kysela over 10 years ago
- Category changed from Descrambling to Configuration
Updated by Rafal Kupiec over 10 years ago
Jaroslav Kysela wrote:
I believe this issue should be resolved in v3.9-2284-g3c5d409 .
confirmed, can be closed.
Updated by