TVH 4.1 on odroid-c2 DVB-S no scan without pre-defined muxes

Hello,

I am facing a very strange issue. I set up Tvheadend 4.1 on an odroid-c2 using DroidPi. As I am also using TVH 4.0.9 on a raspberry pi, I know, that the SAT-IP receiver is working fine. I also had no issues with the scan there.

I added a DVB-S network "Astra19.2E" without selecting "Pre-defined muxes". My understanding is, that TVH will scan my SAT-IP receiver anyways for all available muxes.
After mapping it to the adapters (all activated) I marked the network and hit "Force Scan". And nothing happend...

For testing I set up a second Network "A19E" and selected the "Astra 19.2E" as Pre-defined muxes. Now a lot of muxes appear. Does anyone know, why the scan does not work without the pre-defined muxes?

I also compared the amount of muxes and channels between Raspberry and Odroid:
____________# Muxes___# Services___# Mapped Channels___Scan queue
Raspberry_______131______5986_________879_____________________0
Odroid C2_______111_______614__________66___________________111

Is there an expaination for the huge difference in the number of services? I would expect both to have the same number, since the are connected to the same SAT-IP receiver and dash.

Thanks a lot.

Replies (2)

RE: TVH 4.1 on odroid-c2 DVB-S no scan without pre-defined muxes - Added by Maury Markowitz almost 8 years ago

Mark, I am curious, how did you get a driver for that device at all? IIRC the kernel for the C2 is 3.10.80, which doesn't include the vast majority of the media tree. Were you just lucky that it was in the list of ones it did support?

RE: TVH 4.1 on odroid-c2 DVB-S no scan without pre-defined muxes - Added by Mark Thomas almost 8 years ago

Hi Maury, sorry I did not start the C2 till yesterday. I set it up with the current Version of DietPi. Then installiert TVH with apt-get install tvheadend. Where can I see the driver and the version? I have to verify if I can watch any of the channels

(1-2/2)

Project

General

Profile

Tvheadend